Table of Contents
Advertisement
Technical documentation
201309IA
FMS3000
6.
Configuration
In order to create the configuration, a pre-prepared Excel file is provided. The modules and their
settings are then entered into the file and Excel creates the configuration file on the basis of these
entries. The configuration file is copied onto an SD card, which is inserted into the data module.
In order to load this configuration file into the FMS, the data module is plugged into JR2 (main module)
while it is switched off. When the FMS is switched on, the configuration file is automatically loaded.
LEDs inside the data module will indicate this loading process.
When the loading process has been completed (the LEDs will stop flashing), the FMS restarts
automatically.
After this restart, the FMS must be switched off again one time. Now the data module must be
removed. The configuration procedure is now complete and the FMS can be switched on again. As
last step a RESET must be initiated (via the options menu).
All new settings will take effect only after this RESET step has done.
Tel.: +49 (0)4105 / 65 60 – 0 *
DECKMA GmbH
* Fax: +49 (0)4105 / 65 60 – 25
info@deckma-gmbh.de
www.deckma-gmbh.de
Email:
* Internet:
Version 0.2
27/09/2016
page 13 of 13
Installation Instructions
Advertisement
Table of Contents
