Controlsync - NEC MultiSync EX341R User Manual

ControlSync

ControlSync works controlling all connected sub monitors from master monitor simultaneously but also controlling a target
monitor from master monitor by setting INDIVIDUAL ADJUST function (see page 21).
Controlling all connected sub monitor (Synchronized control):
1. Connect the master monitor with a sub monitor via a ControlSync cable (ø 2.5) into ControlSync IN/OUT.
2. Follow the steps of DATA COPY. When the setting of the master monitor is adjusted, it will be copied and sent to the
connected sub monitor(s) automatically.
3. Up to 24 sub monitors can be daisy-chained via ControlSync.
NOTE: Connect the master monitor via ControlSync OUT connector.
The ControlSync icon will appear on the upper left of the OSD menu in the sub monitor.
Do not connect IN-IN or OUT-OUT.
Do not make "loop" connection.
Once the monitors are connected, turn the master monitor's power key off and on
to check if ControlSync operates correctly.
If monitors are connected with DisplayPort cables, please make sure the monitor, which is connected to a computer is
the master monitor.
Master Monitor
IN (Gray)
Controlling a target monitor (Individual adjust)
1. Touch the MENU/EXIT key to show the OSD menu at master monitor.
2. Move the DOWN/UP key down to select TARGET MONITOR NO. then set sub monitor number.
If you touch the INPUT/SELECT key, each sub monitor displays its monitor number.
In the assumed installation fi gure showed under the OSD menu, master monitor is shown black and sub monitor is shown
yellow.
3. Touch the DOWN/UP key down to select INDIVIDUAL ADJUST then set it to ON.
Control sub monitor's OSD by using master monitor's control keys.
NOTE: To disable INDIVIDUAL ADJUST, touch the SELECT and EXIT keys simultaneously.
Sub Monitor 1
OUT (Black) OUT (Black)
IN
(Black) (Gray)
ControlSync cable
English-10
Sub Monitor 2
OUT
(Black) (Gray)
ControlSync cable
ControlSync icon
IN OUT Up to 24 sub monitors
Next monitor