Table of Contents
Advertisement
Command Set Summary
set snmpcomm [<read|write>]
set telnetport [<port #>]
ssrssi <ch #> <v | h>
survey <sec>
sw 0 [on | off]
sw 1 [on | off]
sw 2 [on | off]
sysinfo
temp
tm
uniimaxpower [<dBm>]
updateflash <mainimage | fpgaimage>
<* | <current chscksum>> <* | <new
checksum>>
updateflash systemsetting
ver
Trango Broadband Wireless — User Manual TrangoLINK Rev. A for F/W Ver. 1.0
It must be in -45 to -75 and +5 dB higher than
RF Rx Threshold
display or assign snmp community string
specify telnet port, <port #> = 1..65534
display rssi on the current channel
spectrum analysis pf the entire band
set sw #0 – packet filter for broadcast/multicast
set sw #1 – HTTPD service
set sw #2 – Auto scan Master signal
display system configuration
display current temperature
display current time mark
set max tx power limit
<dBm> = -30..30
get image from tftp buffer, verify checksum and
write to flash memory at main or fpga image
section.
*: skip checksum verification
write current configuration into flash memory at
system configuration section
display
1.
version number and date code
2.
firmware and fpga version code
3.
firmware and fpga image checksum
SNMP
se
se
se
se
default = 23
se
se
se
se
default = on
se
se
default = on
se
se
R
default = on
se
se
se
se
se
se
se
se
se
se
se
se
se
Page 23
Advertisement
Table of Contents
Need help?
Do you have a question about the TrangoLINK-10 and is the answer not in the manual?