Pyle PDLB372 Installation Manual page 3

Desktop bracket

Enlarged version

Step 6 Using Cable Management

The mount include a cable management function, where cables can be

routed along the length of the arm assembly.

To install cables, you'll first need to remove the cable covers and set all

parts aside.

Cable cover

Fig 5

Route the cables along one side of the Inner Arm (nearest the wall plate).

With cables in place, loosely secure the Inner Arm cable covers back in place.

Next, route the cables along the opposite side of the Outer Arm. Be sure to

leave slack in the cable where it transitions between two sides of the Arm

Assembly. With cables in position, loosely secure the Outer Arm cable

covers back in place.

Note:

For best system performance, route the AC power cable separately

from the signal cables.

With all cables in place, pull the display in and out and check that the

arm assembly moves freely, without stretching or damaging the cables,

and then secure the cable covers.

Important:

DO NOT use a hex wrench on the cable covers, only apply

pressure with your finger.

-6-

Fig 6

Step1

Choose fitting position on the desk.

Choose the position that the Base you want installed.

Important: Make sure there is enough space to spread display, considering

the show size.

Step2 Attach Base

Step2 Attach

Base

The thinkness of the table should be smaller than 55mm

We are not responsible for any personal injury or

product damage due to mishandling, incorrect

mounting, incorrect assembly or incorrect use of

this product.

Fig 1

WARNING

-3-