Advertisement
Step 4: Hanging display
Step 4: Hanging display
Firstly lift the bracket mounted display over the wall mount. And then hook the
brackets over the top of the wall mount. Rotate the display let the bottom of the
brackets hook over the bottom of wall mount, as shown in Fig.4a. Then put safe
bolts into the bottom of the brackets and lock it, as shown in Fig.4b.
Warning:
Warning: Some TV require two people to lift, as we are not responsible for any
personal injury or product damage due to mishandling.
2,3
1
Fig 4a
Thank you for choosing our products
Thank you for choosing our products
Pyle Audio
1600 63rd st , Brooklyn, NY, 11204
(718)236-8000
-8-
5
the facing of a quilt
Fig 4b
Tilt Flat Panel TV Bracket
Multifunctional double deck wall mount
INSTALLATION GUIDE
Item No.:PSW503ST
Item No.:PSW503ST
Easy installing: Just hang up the display
Safety: locking by spinning bolt on the bottom
Weight Capacity:10kg/22lbs~50kg/110lbs
"
"
TV size range: 26 ~42
-
～
Adjustable angle: 5
Inside has balance adjust system
Bulit in leveler system
IMPORTANT: If don't understand about right install ways, please
IMPORTANT:
consult to normal installing specialist.
15
.
.
www pyleaudio com
MADE IN CHINA
Advertisement
Table of Contents
Related Manuals for Pyle PSW503ST
Summary of Contents for Pyle PSW503ST
- Page 1 Fig 4b Tilt Flat Panel TV Bracket Multifunctional double deck wall mount INSTALLATION GUIDE Item No.:PSW503ST Item No.:PSW503ST Easy installing: Just hang up the display Safety: locking by spinning bolt on the bottom Weight Capacity:10kg/22lbs~50kg/110lbs "...
- Page 2 Hardware List: Actual parts appearance and the quantity may different Hardware List: with illustrated. Description Wall mount Left bracket Right bracket Cable Cover Safe bolt Box wrench ×12 bolt ×16 bolt M5× bolt Description M6×16mm bolt M5×36mm bolt M6×36mm bolt Square washer Long bolt Wall anchor...
- Page 3 Install the Cable Cover Install the Cable Cover Step 2: Step 2: Route the cables as required. Snap the cable cover into place onto the rods (Fig. 2a), and then slide the cover into position as required. (Fig. 2b) Fig 2a Step 3: Attach mount to wall Step 3: Attach...
- Page 4 Following examples shows how to use bolts, spacers and square washers. 1.Some displays have vertical backs. No spacer is required. Install the bracket directly to the back of display by using bolts and square washers provided. As shown in Fig.1a. M4 Fig bit M6 Fig bit Fig 1a...
Need help?
Do you have a question about the PSW503ST and is the answer not in the manual?
Questions and answers