Table of Contents
Advertisement
Removing the battery
Attention
Please switch off your phone before
removing the battery!
• To remove the cover, place a
fingernail at the cutout end of the
cover at the top of the phone and lift
the cover off.
• To remove the battery, take hold
of the battery at the corner indicated
and lift the battery up
Charging the battery
The battery is not fully charged when
delivered. Plug the charger cable into
the bottom of the phone, plug the power
supply unit into a mains power socket
and charge for at least two hours.
Only use the plug-in power supply
included in delivery!
As an alternative, the battery can
be charged in the desktop stand or via
the USB port (Accessories, page 123) or
in the desktop stand.
9
.
Getting started
Desktop Stand
During charging the desktop stand is il-
luminated. To switch the lighting off
when charging, turn the desktop stand
upside down. Place the tip of a pencil in-
to the hole on the middle of the stand
and switch the lighting off.
Display during charging.
Y
• In order to avoid damage, the SIM card
should not be removed when the
phone is connected to a charger or
USB cable.
• You can set the navi key to blink
indicating charging (page 115).
Charging time
An empty battery is fully charged after
about 2 hours. Charging is only possible
within a temperature range of
+5 °C to +45 °C (+41°F to +113°F). If
the temperature rises/falls 5 °C
above/below this, the charge symbol
flashes a warning. The mains voltage
specified on the power supply unit must
not be exceeded.
19
Advertisement
Table of Contents
