McCulloch ROB R600 Operator's Manual page 27

Remote start Proportion
Proportion Never
Rarely
Medium
Often
Always
With this function activated, (any option other than
Never is selected) the robotic lawnmower will follow the
guide wire from the charging station to the point where
the guide wire connects to the boundary wire. It begins
to mow when it reaches this point. How often it must
follow the guide wire from the charging station is
selected as a proportion of the total number of times it
leaves the charging station. At all other times, the
robotic lawnmower leaves the charging station in the
standard manner and starts to mow.
The following five options can be selected:
Never (0%)
1.
Rarely (approx. 20%)
2.
3. Medium (approx. 50%)
Often (approx. 80%)
4.
Always (100%)
5.
Select the percentage that corresponds to the size of the
remote area relative to the total working area. If the
remote area is for instance less than half of the total
working area, then Rarely should be selected. If the
remote area is for instance half of the total working area,
Medium should be selected. Compare with the
Yard layout examples on page 30
examples in
Rarely .
The default setting is
358 - 002 -
3.16.6 Calibrate guide, ROB R600
The Calibrate guide function allows you to test if the
robotic lawnmower can follow the guide wire out from
the charging station.
To test the guide wire:
1. Place the robotic lawnmower in the charging station.
Calibrate guide and press OK . The robotic
2. Select
lawnmower will now leave the charging station, run a
calibration process in front of the charging station
and then follow the guide wire to the connection
point with the boundary wire and then start mowing.
3. Check that the robotic lawnmower can follow the
guide wire all the way to the connection point with
the boundary wire.
The test has failed if the robotic lawnmower cannot
follow the guide wire all the way to the connection point
with the boundary wire. It is likely that the installation
has not been carried out in accordance with the
Installation of the guide wire on page 18 .
instructions in
Common errors are for instance that there is not enough
open space to the left of the guide wire as seen facing
the charging station or that the guide wire is not laid at
an angle on a steep slope. See
the guide wire on page 19 .
Rectify the installation and run a new test with
guide .
3.16.7 Reset user settings
This function allows you to reset the robotic lawnmower
to factory default settings.
1. Select Reset user settings in the menu and press
OK . Enter the correct PIN code and press OK .
3.16.8 About
The About menu displays information about the robotic
lawnmower's serial number and different software
versions.
Laying and connecting
Calibrate
Installation - 27