Checking The Installation; First Start-Up And Calibration; Test Docking With The Charging Station - McCulloch ROB R600 Operator's Manual

used to connect each boundary wire. Insert the
guide wire in the centre hole in the coupler.
Check that the wires are fully inserted into the
coupler so that the ends are visible through the
transparent area on the other side of the coupler.
• Use a polygrip to completely press down the
button on the coupler.
7. Staple down/bury the connector in the lawn.
CAUTION: The guide wire may not cross the
boundary wire, for instance a boundary wire that
is laid out to an island.
CAUTION: Test that the guide wire works
before using the robotic lawnmower.

3.8 Checking the installation

Check the loop signal by inspecting the indicator lamp
on the charging station.
20 - Installation
Indicator lamp in the charging station on page 42 if
See
the lamp does not indicate a solid or flashing green light.

3.9 First start-up and calibration

When the main switch is set to position
time, a start-up sequence in the robotic lawnmower's
menu must be carried out as well as an automatic
calibration of the guide signal. The calibration is also a
good test to see that the installation of the guide wire
has been done in such a way that the robotic
lawnmower can easily follow the guide wire from the
charging station.
1. Open the hatch by pressing the STOP button.
2. Set the main switch to position
A start-up sequence begins when the robotic
lawnmower is started for the first time. The following
is requested:
• Language.
• Country
• Current time
• Date
• 4 digit PIN code. All combinations except 0000
are permitted.
MEMO page at the beginning of the
Note: Use the
manual to make a note of the PIN code.
3. Place the robotic lawnmower in the charging station
as requested in the display. Press the START button
and close the hatch. The robotic lawnmower will now
start the guide calibration, by leaving the charging
station and following the guide wire to the point
where the guide wire is connected to the boundary
wire to begin mowing there. Check that the robotic
lawnmower can follow the guide wire all the way. If it
cannot, this may be due to an incorrectly installed
guide wire. In this case, check that the installation is
performed as described in
wire on page 18 . Then carry out a new calibration.
Calibrate guide, ROB R600 on page 27 for
See
ROB R600 and Test settings on page 24 for ROB
R800, ROB R1000.

3.10 Test docking with the charging station

Before using the robotic lawnmower, check that the
robotic lawnmower can follow the guide wire all the way
to the charging station and easily docks with the
charging station. Perform the test below.
1. Open the panel hatch by pressing the STOP button.
2. Place the robotic lawnmower close to the point
where the guide wire is connected to the boundary
1 for the first
1 .
Installation of the guide
358 - 002 -