Xbass; Display Information; Set The Time; Liquid Crystal Display - Blaupunkt MADRID 120BT Owner's Manual

Europe/USA/LAT area.
OPERATION
EQ (Equalisation)
Press EQ button shortly to select the preset
EQ mode as below:
FLAT-CLASSICS-POP-ROCK-EQ OFF

XBASS

Press and hold the EQ button for 2 seconds
to active the XBASS function. Press it and
hold it again to cancel this function.

DISPLAY INFORMATION

Press DISP button (1) to show the time for
5 seconds. Then it returns to show the
information.

SET THE TIME

(1) Manual setting:
Press and hold DISP button for 2 seconds.
The hour of the time will be flashing. Press
/ button to set the correct hour.
Press DISP button shortly to change to
minute. Also use
correct minute. After that press DISP button
to confirm.
(2) Synchronize the time from the RDS
station:
To receive a RDS station which has good
signal(The AF symbol of the LCD does not
flashing). Several minutes later the time will
be synchronized to the correct time by the
station's signal. (Note: None RDS station
does not have this function.)

LIQUID CRYSTAL DISPLAY

Exhibit current frequency and activated
functions on the display.

ESP FUNCTION

The unit can be shockproof between ten
seconds and twenty seconds.
/ button to set the

AUXILIARY INPUT

The unit can be connected to a portable
audio player through the AUX IN jack (11).
Pressing SRC button to switch to AUX
mode when inserted an audio source to the
unit.

RESET FUNCTION

RESET button (25) must be activated with
either a ballpoint pen or thin metal object.
The RESET button is to be activated for the
following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: if press RESET button (25), the unit
can't work yet, please use a cotton swab
soaked in isopropyl alcohol to clean the
socket on the front panel.

RADIO OPERATION



SWITCHING TO RADIO MODE

Press SRC button (2) to select radio
mode, the radio mode appears in the
display together with the memory band
and frequency.

SELECTING THE RADIO BAND
At radio mode, press BAND button (5)
to select the desired band.
The reception band will change in
following order:
→FM1→ FM2→ FM3 → MW1(AM1)→ MW2(AM2)


SELECTING STATION

Press
(24) shortly to activate automatic seek
function. It will search up/down a station
10
button (22) or button