Safety Instructions; Connectors; Connecting One Or Two Record Players; Connection To The Amplifier - Pro-Ject Audio Systems Tube Box DS2 Instructions For Use

Table of Contents

Dear music lover,

Thank you for purchasing a tube phono preamplifier from Pro-Ject Audio Systems.

In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse

Important notice

Safety instructions

AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the

voltage in your area meets the voltage requirements printed on the power supply.

The power supply is used to connect/disconnect the unit from the mains. Make sure that the power

supply is easily accessible at all times. Never handle the device, the power supply while your hands are

wet or damp. Avoid letting liquids enter the device or the power supply. Never place any item

containing liquid, such as a flower vase on or near the device. Never spill any liquid on the device or

the power supply. Never place any naked flame sources, such as lighted candles on or near the device.

The product shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool or any

other similar conditions.

Make all connections whilst the phono amplifier is disconnected from the power supply.

Do not connect the phono amplifiers output to a phono input (sometimes labelled gram, disc or RIAA)

on the amplifier.

Never use any other power supply than the one supplied with the unit.

Connect left and right channels of the tonearm signal lead to the sockets marked IN1 or IN2 of the phono

amplifier. The earthing wire may be connected to the screw terminal if you encounter hum problems when

using the record player.

Connect the output sockets marked OUT1 or OUT2 of the phono amplifier to one or two line inputs (such as

AUX, CD, Tuner, Tape or Video) on your amplifier.

Connect the low voltage plug from the power supply to the Power 18V DC socket of the phono amplifier

before connecting the power supply to the mains.

Table of Contents

Do you have a question about the Tube Box DS2 and is the answer not in the manual?