Advertisement
Dear music lover,
thank you for purchasing a Pro-Ject Audio Systems´ amplifier.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.
Warning of a hazard for the user, the unit or possible misuse.
Important notice.
Safety instructions
AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the
voltage in your area meets the voltage requirements printed on the power supply.
The power supply is used to connect/disconnect the unit from the mains. Make sure that the power supply
is easily accessible at all times. Never handle the device, the power supply while your hands are wet or
damp. Avoid letting liquids enter the device or the power supply. Never place any item containing
liquid, such as a flower vase on or near the device. Never spill any liquid on the device or the power
supply. Never place any naked flame sources, such as lighted candles on or near the device. The product
shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar
conditions.
Connectors
1. Make all connections except the connection to the headphone whilst the unit is disconnected from
the mains.
2. Never connect or disconnect power supply to or from the unit whilst the power supply is connected to
the mains! Never use any other power supply than the one supplied with the unit with the exception of
dedicated Power Boxes which can replace original power supplies.
3. Take care to connect the left and right channels of
usually marked red, the left channel black or white.
.
4
Speaker connections for the left speaker are located on the right hand side of the rear view. Speaker
connectors marked red represent
Analog output (Variable)
A power amplifier, active loudspeakers or an active subwoofer can be connected to the output sockets marked
Analog Output.
Connection to the speakers
The output terminals accept speaker cables terminated with 4mm ∅ Banana plugs, spades connectors or
naked wire.
2
© Pro-Ject Audio Systems · MaiA S3 · Revision 2022.01.03
In 1
In 2
,
+
according indicators on speaker terminal.
In 3, In 4
,
correctly. The right channel is
Advertisement
