Table of Contents
Advertisement
RADIO OPERATION
BAND SELECTION
At tuner mode, press BND/LOU button (13) shortly to select the desired band.
The reception band will change in the following order:
FM1
STATION SELECTION
Press TUNE/SEEK
automatic seek function. Press for several seconds until "MANUAL" appeared on the
display, the manual tuning mode is selected. If both buttons have not pressed for
several seconds, they will retune to seek tuning mode and "AUTO" appeared on the
display.
LOCAL/DISTANCE
Press LOC button (1) shortly to select between local and distant stations. Local
setting for reception of strong station, and a distant setting for reception of weaker
stations.
This function is effect during AUTO SEEK operation.
AUTOMATICALLY MEMORY STORING & PROGRAM SCANNING
- Automatic Memory Storing
Press AMS button (18) for several seconds, the radio searches from the current
frequency and checks the signal strength until one cycle search is finished. And
then 6 strongest stations are stored into the corresponding preset number button.
- Program Scanning
Press AMS button (18) shortly to scan preset station. When the field strength level
is more than the threshold level of stop level, the radio is holding at that preset
number for several seconds with release mute, then searches again.
STATION STORING
Press any one of the preset buttons (14) (M1 to M6) to select a station, which had
been stored in the memory. Press this button for several seconds, current station is
stored into the number button.
MONO/STEREO
Press MONO button (26) to select mono or stereo mode. You can sometimes
improve reception of distant stations by selection mono operation.
SCAN
Press SCAN button (2) to set the function to scan mode, which scanning to higher
frequency station with receivable signal and keep on each station for several
seconds.
FM2
FM3
button (16) or TUNE/SEEK
9
AM
button (17) shortly to activate
Advertisement
Table of Contents
