Pyle PLPK65TVD Owner's Manual page 40

Mobile video system
Table of Contents

Advertisement

SOUND ADJUSTMENT
Press SEL button (10) to select the desired adjustment mode.
The adjustment mode will change in the following order:
Volume
Bass
By pressing VOL
button (11) or VOL
desired sound quality.
LOUDNESS
Press BND/LOU button (13) for several seconds to reinforce the bass output and
display will show "LOUD".
Press it for several seconds again to release this function.
SET THE CLOCK
Holding down the DSP button (15) until the clock is shown on the display and flashes.
Then press the TUNE/SEEK
(16) to change minutes.
SELECT MODE
Press MOD button (6) to choose desired listening mode.
(e.g. radio mode to cassette mode to CDC mode or AUX IN mode)
MUTE
Press MUT button (3) to silence the receiver. Press it again to resume listening.
VACUUM FLUORESCENT DISPLAY
Exhibit current frequency and activated functions on the display (8).
EQUALIZATION
Press EQ button (19) to turn on equalization function and to select desired audio
mode.
There are five kinds of mode as below:
FLAT
REMOTE SENSOR (OPTIONAL)
Point the remote control handset to the remote sensor RX (27).
Press the function keys on the handset to control the system.
FLASHING LED
If the front panel does not install in the unit, the LED (29) will be flashing.
RESET
RESET button (30) must be activated with either a ball point pen or thin metal object.
RESET button (30) is to be activated for the following reasons:
- Initial installation of the unit when all wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: If press RESET button (30), the unit can't work yet, please use a cotton swab
soaked in isopropyl alcohol to clean the socket on the front panel.
Treble
Balance
button (12), it is possible to adjust the
button (17) to change hours or TUNE/SEEK
CLASSICS
POP
8
Fader
JAZZ
DSP OFF
button

Advertisement

Table of Contents
loading

Table of Contents