Advertisement
Check line voltage. Data indicated on the type
plate must match technical data of the mains
supply.
Please unplug the pump after operation and
before carrying out any maintenance works.
The pump must not be operated when there
are people in the water. Swimming pools and
garden ponds should be designed according
to international and national design regulati-
ons.
v Please consult a professional electrician.
For Austria :
Pumps for use on swimming pools and on
ponds may only be operated via an isolating
transformer.
v Please consult a professional electrician.
For Switzerland :
In Switzerland mobile appliances which are
used outdoors, must be connected via a resi-
dual-current device.
3. Initial Operation
Connecting the hose s:
3 /4"
1"
1"
1 1/ 4 "
1 1/ 4 "
"
1 1/ 2
"
1 1/ 2
FSP 2000
FSP 5500 DUO
FSP 3000
FSP 8000 DUO
FSP 15000 DUO
1
2
3
Note :
Do not allow the pump to run without
water because dry-running leads to an
undesirable build up of heat.
Before operating the pump, look to see if there
is any damage of the pump (esp. regarding
power cable and plug). The connection cable
of the pump cannot be replaced. If the cable is
damaged the pump must be scrapped.
Do not use the power cable to carry the pump
or to pull the plug out of the socket. Protect
the power cable from heat, oil and sharp
edges.
The temperature of the liquid used must not
be below 4 °C or above 35 °C.
Sand and other abrasive substances in the
liquid cause increased wear and reduce the
output of the pump.
Please observe the local noise prevention
regulations.
The universal connector
2000 / FSP 3000 only ), 1",1 1/ 4" and 1 1/ 2 " hoses.
To achieve the best pumping results (maximum delivery rate of
the pump) use a 38 mm (1 1/ 2 ")-hose. We recommend that you
secure all hoses using GARDENA Hose Clips art. no. 7192 -
7195.
1. Depending on the hose, cut away the parts of the universal
connector you do not need using a saw.
Otherwise loss of performance could occur.
2. Screw universal connector
3. Connect hose to the universal connector
Only for FSP 5500 DUO / FSP 8000 DUO / FSP 15000 Duo :
4. Screw universal connector with ball and socket joint on to the
2
distribution intake
5. Screw universal connectors without ball and socket joint on to
the distribution outlets
6. Connect pump hose to the distribution intake
7. Connect the hoses of the consumers (filter / stream) to the
distribution outputs
1
can be used to connect 3/ 4" (for FSP
1
on to the pump.
1
.
3
.
3
.
.
2
.
9
Advertisement
