Trouble-Shooting - Gardena PF 10000 S Operating Instructions Manual

8. Trouble-Shooting

Changing the bulb :
S
U
W
X
T
V
Cleaning the pump :
z
3 8
z
3 7
Y
20
DANGER ! Electric shock !
A
v v Before undertaking Trouble-Shooting, unplug the
UVC-unit and the pump from the mains !
The UVC bulb should be replaced after approximately 8,000
operating hours since the UVC performance decreases
dramatically after this time.
Only bulbs of the type TC-S (UV-C) may be used. (E. g. Radium,
Philips or Sylvania). The correct UVC-bulb can be ordered from
GARDENA Service as a spare part.
1. Remove the cover of the UVC device
S
device
2. Carefully unscrew the ring
3. Pull off the glass tube
the glass tube due to mineral deposits.)
4. Take out faulty bulb
5. Reassemble the UVC unit in reverse order.
DANGER ! Short-circuit !
A
v v The ring
guarantee that the glass tube
During assembly, ensure that the O-Ring
T
tube is positioned correctly and the O-Ring
correctly in the UVC device
reassembled to test the functioning of the bulb.
1. Remove pump from pump housing (see 7. Mainenance
" Cleaning the pump housing of the pump " ).
2. Turn pump cover
motor housing
3. Draw rotor unit
4. Push cleaned rotor unit
z
3 6
5. Press pump cover
and close by turning clockwise.
During this, ensure that the O-ring
6. Assemble pump in the pump housing.
(see 7. Maintenance " Cleaning the UVC Unit" ).
V
.
T
(It may be relatively difficult to remove
W
and insert new bulb.
U
must be screwed on firmly again to
S
. The UVC unit must be fully
Y
anti-clockwise and draw vertically out of the
z
3 6 (bayonet fitting).
z
out of motor housing
3 7
z
back into the motor housing
3 7
Y
vertically on to the motor housing
S
and remove the UVC
T
is sealed !
X
on the glass
U
is inserted
z
and clean.
3 6
z
3 6
z
3 6
z
is installed correctly.
3 8
.