Gardena PF 10000 S Operating Instructions Manual page 8

Removing fine dirt :
I
N
M
H
Cleaning the pump housing
of the pump :
P
Q
Cleaning the UVC unit :
F
S
2
U
1
T
If the removal of the severe soiling is not sufficient, the fine soiling
must be removed.
Do not use any chemical cleaning agents so that the bacteria
are not killed.
1. Unscrew the connecting hose and the return hose.
2. Open the sealing clamps
UVC device from the filter housing
3. Unscrew the screw nut
remove the filter sponges
4. Clean the filter sponges
squeezing at the same time.
5. Rinse the lava stone
L
in clean water (do not clean under running water).
6. Empty filter housing
water.
K
7. Assemble the pressure filter again in reverse order. Ensure that
z
m
the O-Ring
O
8. Start operation of the pressure filter again (see 5. Initial
Operation " Operating the UVC Pressure Filter Set" ).
J
1. Take pump out of the water.
2. Unscrew the connecting hose.
3. Unlock snap fastening
4. Take pump
R
5. Clean pump housing
6. Re-assemble pump in reverse order.
1. Remove the cover
2. Turn the UVC device
2 (bayonet coupling).
3. Clean the glass tube
example).
4. Fit the UVC device again in reverse order.
During assembly, ensure that the O-Ring
is installed correctly.
H
and remove the filter cover
z
m of the filter sponge bracket
L
from the filter cover
L
under running water while
M
and the bio-surface elements
J
completely and clean under running
O
is sitting correctly.
P
and open up the pump housing
R
out of the pump housing
Q
with a jet of water.
F
of the UVC device
S
anticlockwise 1 and pull out carefully
T
(using liquid glass cleaner, for
I
J
.
K
and
I
.
N
gently
Q
.
S
.
U
of the UVC device
with
Q
.
19