Changing Your User Admin Code; Low Battery Indicator; New Admin Code - SimpliciKey SRCED3 Programming & Operation Manual

CHANGING YOUR USER ADMIN CODE

enter your Default Admin Code (see below) or the existing User Admin
Code and press the * key to begin Admin mode.
Default Admin Code
Critical Point
If the keypad flashes and a multi-tone alert
goes off at any point in admin mode, you have
taken too long and will have to start over from
the first step.
Next, enter ADMIN (23646) on the keypad and press the * key.
A - D - M - I - N
Next, enter a new 4–6 digit Admin Code and then press the * key.

New Admin Code

Finally, repeat your entry of your new 4–6 digit Admin Code and then
press the * key.
New Admin Code
You will then receive the final confirmation tone and the keypad will flash
twice to let you know that the User Admin Code has been changed.
New Admin Code
We recommend that you write down
your new Admin Code here and keep
this manual in a safe place.
New Admin Code
12
DO NOT THROW AWAY UNTIL YOU HAVE SAFELY STORED YOUR ADMIN CODE
-
WARNING: SimpliciKey submits that no lock,
by itself, can provide complete security. As
with other mechanical and electronic
locking devices, the security of this lock has
the potential to be compromised. We remind
all our customers to exercise good safety
procedures as part of your home security
plan. SimpliciKey locks are manufactured to
ANSI Grade 2 specifications. For added levels
of security, consult a qualified locksmith or
security expert.

LOW BATTERY INDICATOR

When the 4 (AA) batteries get low, SimpliciKey will emit an alert tone and the low
battery indicator LeD and exterior LeD will flash for approximately 15 seconds.
Please be sure to replace your batteries at this time in order to ensure proper
operation of SimpliciKey.
Low Battery Indicator LeD
exterior LeD
13