Keypad Instructions - SimpliciKey SRCED3 Programming & Operation Manual

KEYPAD INSTRUCTIONS

Critical Point
Your administration code (Admin Code) can be found on the
back of this booklet. The Admin Code can be changed by
following instructions on page 12.
Command
Add Key Code
1. enter your Admin Code, press *
2. enter "ADD CODE", press *
3. enter the new Key Code, press *
NOTE: Code can be 4-7 digits
4. Repeat the new Key Code, press *
*If error tone, start over
5. Test the new Key Code, press
Delete a Key Code
1. enter your Admin Code, press *
2. enter "DEL CODE", press *
3. enter the Key Code to be deleted,
press *
4. Repeat the Key Code to be deleted,
press *
5. Test the deleted Key Code,
press
Delete all Key Codes
1. enter your Admin Code, press *
2. enter "DL CODES", press *
3. Repeat "DL CODES", press *
4. Test the deleted Key Codes,
press
Press
Enter Admin Code
A - D - D - C - O - D
enter
New Key Code
Repeat
New Key Code
Test
New Key Code
Enter Admin Code
D - E - L - C - O - D -
enter
Key Code to Delete
Repeat
Key Code to Delete
Test
Delete Key Code
Enter Admin Code
D - L - C - O - D - E -
D - L - C - O - D - E -
Test
Delete Key Code
10
Your administration code (Admin Code) can be found on the
back of this booklet. The Admin Code can be changed by
following instructions on page 12.
Command Command
Simple Lock Feature
enables to lock
without entering a Key Code
- E -
1. enter your Admin Code, press *
2. enter "LOCK" and press *
To turn simple lock oN, press 1, *
and repeat
To turn simple lock oFF, press 2, *
and repeat
Quiet Lock Feature
Turn on / off keypad sounds
1. enter your Admin Code, press *
E -
2. enter "SoUND" and press *
To turn sound oN, press 1, *
and repeat
To turn sound oFF, press 2, *
Master Reset Feature
Clears all stored codes, settings,
and remote control keyfobs.
All codes and keyfobs will need to
be reprogrammed after performing
S -
this feature.
S -
Critical Point
KEYPAD INSTRUCTIONS
Critical Point
Press
L/ UL Button (used for locking only)
Enter Admin Code
L - O - C
Enter Admin Code
S - O - U
Remove one battery
Press and hold any
button and re-insert the
4th battery. Continue
holding button for about
5 seconds after battery
has been inserted
If the keypad flashes and a multi-tone alert
goes off at any point while in admin mode, you
have taken too long and will have to start over
from the first step.
11
- K -
To turn on simple lock
To turn off simple lock
- N - D -
To turn on sound
To turn off sound