Daily Use Instructions; Remote Control Keyfob Instructions - SimpliciKey SRCED3 Programming & Operation Manual

DAILY USE INSTRUCTIONS

1. Remote Control Keyfob
STOP! Test your keyfobs now before attempting to program.
SimpliciKey comes factory programmed with the keyfobs included
in the package. If the keyfobs are not registered with your lock, or to
add additional keyfobs (up to the maximum limit of 8), please see the
instructions on page 8.
Press to Lock
2. Keypad Key Codes
For your security, SimpliciKey requires that you enter your own Key
Codes to activate this feature. Please see the instructions on page 9 to
add up to 16 Key Codes.
When Unlocked:
enter your Key Code and Lock/ Unlock button (
Key Code
When Locked:
enter your Key Code and Lock/ Unlock button (
Key Code
3. Keypad Settings
For your convenience, the keypad has options for quiet operation and
faster locking, with instructions on page 10.
When simple lock is oN, pressing the Lock/Unlock button (
door.
When simple lock is oFF, the user will have to enter the Key Code
and press the Lock/Unlock button (
Step 2.
When quiet lock is oFF, the keypad will emit softer tones during operation.
4. Manual Key Use
SimpliciKey offers a bump-resistant 6-pin keyway should you choose
to use a metal key for entry.
Press to Unlock
) to lock
) to unlock
) will lock the
) to lock the door as shown above in
8

REMOTE CONTROL KEYFOB INSTRUCTIONS

STOP! Test your keyfobs now before attempting to program.
Critical Point
Your administration code (Admin Code) can be found on the
back of this booklet. The Admin Code can be changed by
following instructions on page 12.
The lock may time out if too much time passes between entering
commands. If this happens, you will need to start over.
Command
Add Remote Control Keyfob
1. enter your Admin Code, press *
2. enter "ADD FOB", press *
3. The blue LeD below the keypad
will begin to flash. You will have
nine seconds to register your keyfob.
4. While the blue light is flashing, press
both keyfob buttons for no more than 1
second. If you do not get the happy
tone, press both buttons immediately
again. If the tone is happy, then you're
right, if it sounds like a chirp then start
over.
Delete an Individual Remote Control
Keyfob
1. enter your Admin Code, press *
2. enter "DEL FOB", press *
3. Press and hold either keyfob button
4. Test the keyfob
Delete all Remote Control Keyfobs
1. enter your Admin Code, press *
2. enter "DEL FOBS", press *
3. Repeat "DEL FOBS", press *
4. Test the keyfobs to confirm
Press
Enter Admin Code
A - D - D - F - O - B
Press and
Test
hold
both
Enter Admin Code
D - E - L - F - O - B
Press and Test
hold either both
Enter Admin Code
D - E - L - F - O - B - S
D - E - L - F - O - B - S
Test
both
9
-
-
-
-