Kwikset SmartCode 914 Installation And User Manual page 3

7 Pair the lock with your smart home system
A
Initiate the pairing process through
your smart home system (either
through your smart home app, at your
panel, or at your controller or hub).
Refer to your smart home system
instructions for more information.
8
Add user codes (30 maximum)
It is recommended that you add and delete all user codes through your smart home system.
If your system does not allow this, codes may be added directly to the lock as shown here.
A
Programming information
Mastercode: For enhanced security, a
mastercode may be used when adding
and deleting user codes. For more
information about the mastercode,
download the SmartCode 914
Programming and Troubleshooting
Guide at www.kwikset.com.
Programming Timeout: During
programming, if no button is pressed
for ive seconds, the system will time
out (indicated by three beeps and a red
lashing keypad), and you will need to
restart the procedure.
E
What lights and sounds does the lock produce?
One green lash with one beep
green
Programming was successful.
Test the lock and check door alignment
9
A
With the door open, press the Lock
button. Con irm that the door locks.
10
Re-key the lock (if needed) and install the battery cover
A
Optional: Re-key the lock.
a
b
K
IMPORTANT: Re-key the lock
Remove battery to work with your
pack before existing key. See
re-keying. the supplied
SmartKey Re-key
instructions for
more information.
B
When prompted by your smart home
system to initiate pairing at the lock, press
button "A" on the lock interior four times.
button "A" button "B"
B C
Make sure the door is open.
Press the Program button once.
or
1x
B
Enter the user code(s) added
in the previous step. Con irm
that the door unlocks.
c
Reinstall
battery
pack.
H
3 / 4
C
If the pairing process is successful, re-name
the lock in your system (if applicable).
D
If the pairing process is unsuccessful,
press button "B" nine times.
Perform steps 7A 7C again.
If still unsuccessful, follow your smart home system's
instructions to remove (exclude/unpair) the lock from
any other network. Then perform steps 7A 7C again.
D
Enter a new user code. A total of 30 Press the Lock button once.
user codes may be programmed.
Each user code
must be a unique
code between
4 and 8 digits,
depending on
your smart home
system.
Three red lashes with three beeps
red
3x
Programming was unsuccessful.
Move swiftly through Make sure the user code is
programming, as the not a duplicate and that it
system will time out if is between 4 and 8 digits
no button is pressed during your next attempt.
for ive seconds.
*Beeping sound will only be heard if switch #3 (on the lock interior) is in the on positon.
C D
Close the door. Press the Lock
button. Con irm that the door
locks smoothly without error.
B
Install the battery cover.
a
K
M
Make sure the lock has
room for an additional code.
If all user code positions
are illed, delete a code to
make room for this one.
If your does not lock smoothly,
make sure you replaced your
previous latch and strike with
those supplied in the box.
If you still experience locking
errors, call Kwikset Support to
order a Warped Door Service Kit.
Kwikset Support: 1 866 863 6584
actual
size
V
b
V (3x)