Kwikset SmartCode 914 Installation And User Manual

66863 001
Rev 02
ZigBee
Installation and User Guide
Required tools
Ruler Phillips head screwdriver
Additional Tools (depending on application)
Hammer Wood block Chisel
1
Begin with your smart home app
If you will be using a smart home app with your lock, download the app and set up
your controller or hub before proceeding further with lock installation.
Prepare the door and check dimensions
2
Make sure your door is compatible. If you have a standard deadbolt mounted
A
separately from the handle below it, your door is compatible.
Compatible
Not Compatible
Measure to con irm that the hole in the door is either
C
2 1/8" (54 mm) or 1 1/2" (38 mm).
Note: Additional door
2 1/8"
preparation may be
required for doors with
54 mm
1 1/2" (38 mm) holes.
or
Consult the deadbolt
drilling instructions at
1 1/2"
kwikset.com/doorprep
38 mm
3
Install the latch and strike
A
Is the door edge chiseled?
YES
or
chiseled
Use latch "A". If the Use latch "B" (not
latch bolt is not already included). If the latch
extended, extend the bolt is not already
latch bolt as shown. extended, extend the
latch bolt as shown.
A
Kwikset
1 866 863 6584
www.kwikset.com
Not Compatible
Rim Mortise
Lock Lock
Measure to con irm that the backset is
D
either 2 3/8" or 2 3/4" (60 or 70 mm).
b a
c k
s e
t
2 3/8" or 2 3/4"
60 or 70 mm
actual
size
N
B
Hold the latch in front of the door hole, with the latch
face lush against the door edge.
NO
not
chiseled
A
B
C
Is the D-shaped hole centered in the door hole?
YES
D-shaped hole
No adjustment is required.
Proceed to next step.
1 / 4
Parts List
Latch Exterior Assembly
A
B
F
"B" is not included.
If needed, please contact
Kwikset to order a drive-in
Batteries
latch for your lock.
Strike Keys
W
C E
Adapter Mounting SmartKey
Ring Plate Tool
D G
If drilling a new door, use the supplied template and the complete
door drilling instructions available at kwikset.com/doorprep
B
Not Compatible
Integrated
Interior
Measure to con irm that the hole
E
in the door edge is 1" (25 mm).
1"
25 mm
P Q
D
Which latch are you installing?
Latch "A"
B
NO
or
D-shaped hole
Rotate latch face as
shown to extend latch.
E
Install the strike on the door frame.
A
Make sure the hole in the door frame is drilled a
minimum of 1" (25 mm) deep.
B
Interior Assembly
M
L
K
Fasteners
03809 46780
Q
N
P S
48654 49191 64109
T
U V
H
Remove your existing deadbolt
from your door.
Measure to con irm that the door is between
F
1 3/8" and 2" (35 mm and 51 mm) thick.
1 3/8" –2"
35 – 51 mm
S
Latch "B"
or
B
UP is
on top.
UP is
A
on top.
N (2x)
wood
block
Longer screws
install closest to
the door jamb.
S (2x)
C
Q (2x)
door frame