Delta Electronics INX-1K User Manual page 11

Step 4: Communication connection
USB port
RS-232 port
To allow for unattended UPS shutdown/ start-up and status monitoring, connect
the communication cable one end to the USB/ RS-232 port and the other to the
communication port of your PC. With the monitoring software installed, you can
schedule UPS shutdown/ start-up and monitor UPS status through PC.
The UPS is equipped with mini slot perfect for Delta mini SNMP, Relay I/O, Modbus
or TVSS cards (optional). When installing mini card in the UPS, it will provide
advanced communication and monitoring options.
NOTE :
1. The USB port and RS-232 port can't work at the same time.
2. If you choose to use the USB port rather than RS-232 port, please install
the USB driver software in your computer after connecting your computer
to the UPS's USB port. The software can be downloaded from http://www.
deltapowersolutions.com/en-in/mcis/1kva-3kva-single-phase-ups-inx-
series-downloads.php.
Step 5: Turn on the UPS
Press the ON/ MUTE button on the front panel for two seconds to power on the
UPS.
NOTE :
The battery charges fully during the first five hours of normal operation. Do
not expect full battery run capability during this initial charge period.
Chapter 2
8
Installation and Setup
Mini slot