Control Horn And Servo Settings - PARKZONE Conscendo Advance Instruction Manual

EN
Wing Installation continued
1. Align the 4 wing bracket pins with the with the 4
corresponding fuselage holes as shown.
2. As you align the wing, guide the aileron servo wires
through the hole leading to the receiver compartment on
the underside of the fuselage.
3. Use 4 screws to secure the wing assembly to the fuselage
as shown.
4. Open the receiver hatch by removing the screw.
5. Connect the left and right aileron servos to the pre-
installed Y-harness. The left and right aileron servos can
be connected to either side of the Y-harness.
6. Secure the receiver hatch back into place using the screw.
IMPORTANT: Correct operation of the SAFE system requires
connection of both ailerons to the included Y-harness and the
AILE channel of the receiver.
Disassemble in reverse order.
Control Horn and Servo Arm Settings
The illustration shows recommended hole settings in the servo arms
and control horns.
6
1
2
4
5
Elevator
3
OR
Ailerons Rudder