Assembly - PARKZONE Conscendo Advance Instruction Manual

Assembly

Installing the Tail
1. Slide the horizontal stabilizer tube (A) into the hole in the
rear of the fuselage.
2. Install the 2 piece (left and right) horizontal stabilizer as
shown. Ensure the control horn faces down.
3. Secure the 2 piece tail in place with the 2 included pieces
of tape (B). Install a piece of tape on the top and bottom of
each horizontal tail section as shown.
Attaching the Clevis to the Control Horn
Finish the installation of the tail by connecting the control rod
with the clevis on the tail control horn under the elevator.
1. Open the clevis and put the pin in the center hole (A) of
the control horn.
2. If needed, remove the clevis from the control horn.
- Turn the clevis (as shown) on the control rod (also called
a pushrod).
- Close the clevis onto the control horn and slide the tube
towards the horn to secure the clevis.
Wing Installation
1. Slide the left and right wing halves over the wing tube (A)
as shown.
2. Secure the wing halves together with the wing bracket (B).
1
A
1
Clevis
A
1
A
2
B
2
Control
Horn
2
EN
B
5