Lexus RC350 Owner's Manual page 248

248
4-5. Using the driving support systems
WARNING
To avoid malfunction of the camera sensor
■
Observe the following precautions.
Otherwise, the camera sensor may not operate properly, possibly leading to an acci-
dent resulting in death or serious injury.
Keep the windshield clean at all times.
●
• If the windshield is dirty or covered with an oily film, water droplets, snow, etc.,
clear the windshield.
• If a glass coating agent is applied to the windshield, it will still be necessary to use
the windshield wipers to remove water droplets, etc. from the area of the wind-
shield in front of the camera sensor.
• If the inner side of the windshield where the camera sensor is installed is dirty, con-
tact your Lexus dealer.
Do not attach objects, such as stickers, trans-
●
parent stickers, and so forth, to the outer side
of the windshield in front of the camera sensor
(shaded area in the illustration).
A: From the top of the windshield to approxi-
mately 0.4 in. (1 cm) below the bottom of the
camera sensor
B: Approximately 7.9 in. (20 cm) (Approxi-
mately 4.0 in. [10 cm] to the right and left
from the center of the camera sensor)
If the part of the windshield in front of the camera sensor is fogged up or covered with
●
condensation or ice, use the windshield defogger to remove the fog, condensation or
ice. (P. 338)
If water droplets cannot be properly removed from the area of the windshield in front
●
of the camera sensor by the windshield wipers, replace the wiper insert or wiper
blade.
If the wiper inserts or wiper blades need to be replaced, contact your Lexus dealer.
RC350_RC300 AWD_RC300_RC F_U(OM24748U)