Configuration-Specific Settings; Ethernet Settings - Kaba B-eco Manual

Manual
6.5

Configuration-specific settings

6.5.1

Ethernet settings

6.5.1.1 Assigning fixed terminal network parameters
6.5.1.2 Assigning terminal network parameters via DHCP
6.5.1.3 Requesting DNS settings via DHCP
B-eco
In the following, we present the required settings for various device configurations.
The settings can be made using service functions in the menus of the service mode,
see BECO service module manual.
It is also possible to transfer the parameters in the reboot.cmd file via FTP to the
device, see BECO service module manual.
The following parameter examples correspond to the entries in this file.
These settings are required if the terminal is integrated into an Ethernet network. For
details, please see the BECO service module manual.
[Ethernet]
DHCP Mode=disabled
Terminal Addr=10.10.5.85
Netmask=255.255.0.0
Gateway Addr=10.10.1.101
DNS Configuration from DHCP=disabled
DNS Addr=0.0.0.0
[Ethernet]
DHCP Mode=enabled
DNS Configuration from DHCP=disabled
DNS Addr=0.0.0.0
[Ethernet]
DHCP Mode=enabled
DNS Configuration from DHCP= enabled
04043988 - 02/2014
Start-up
47