Protrusion Of The Picture From The Lcd Panel And The Blurring Of Characters - Wacom DTF-521 User Manual

Protrusion of the Picture from the LCD Panel and the Blurring of Characters...

Caution
Depending on the type of computer and graphics board, the Auto-Adjust function is sometimes not
able to operate at full power, resulting in the picture blurring and protruding from the LCD panel. If
this happens, adjust the pitch and phase. At 1024 x 768-bit, the resolution is optimally adjusted.
Procedure:
1
Open the Tablet Control Panel (see
page 22) and select the Calibrate
tab.
2
Click on the Calibrate... button. An
adjustment pattern for pitch and
phase will appear.
3
Using the OSD contorls, open the
OSD Menu and the Pitch icon.
4
Adjusut the pitch level so the pat-
tern of fine vertical stripes display
evently.
5
In the OSD Menu, select the
Phase icon.
6
Adjust the phase level so the adju-
sutment pattern shows clearly.
7
After completing these adjust-
ments, press the ENTER and
MENU buttons to exit the OSD
Menu.
8
Click on the CANCEL button or
press the ENTER and MENU
buttons to exit the OSD Menu.
For Windows 2000, the pitch and phase may be calibrated after the Exit
Hint
Windows screen is displayed. If the frequency needs to be calibrated, light
and dark vertical stripes will appear in the dark areas of the screen. If the
tracking needs to be calibrated, light and shade will appear horizontally in the
dark areas of the screen (for 1024 x 768-bit resolution).
This method is recommended in situations where the tablet driver has not
been installed.
This setting is effective when the product and computer are connected by a
RGB cable.
1
2
Adjustment pattern for pitch and phase
15