Supero 1022GG-TF User Manual page 54

A+ Server 1022GG-TF User's Manual
BMC Jumper
JBMC1 is used to enable or disable theBMC
(Baseboard Management Control) Chip and
the onboard IPMI connection.This jumper is
used together with the IPMI settings in the
BIOS. The default position is on pins 1 and
2 to Enable BMC. See the table on the right
for jumper settings.
Watch Dog Enable/Disable
JWD enables the Watch Dog function, a
system monitor that takes action when a
software application freezes the system.
Jumping pins 1-2 will have WD reboot the
system if a program freezes. Jumping pins
2-3 will generate a non-maskable interrupt
for the program that has frozen. See the
table on the right for jumper settings. Watch
Dog must also be enabled in BIOS.
LAN1/2 Enable/Disable
Change the setting of jumper JPL1 to enable
to enable or disable the LAN1 and LAN2
Ethernets ports. See the table on the right
for jumper settings. The default setting is
enabled.
VGA Enable/Disable
JPG1 allows you to enable or disable the
VGA port. The default position is on pins 1
and 2 to enable VGA. See the table on the
right for jumper settings.
BMC Jumper Enable (JBMC1)
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Jumper Settings (JWD)
Jumper Setting
Pins 1-2
Pins 2-3
Open
Note: when Watch Dog is enabled, the user
must write their own application software to
disable the Watch Dog Timer.
LAN1/2 En/Disable
Jumper Settings (JPL1)
Jumper Setting
Pins 1-2
Pins 2-3
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
18
Defi nition
Enabled (default)
Disabled
Watch Dog
Defi nition
Reset
NMI
Disabled
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled