Patch Mode - Stereoping synth programmer Owner's Handbook Manual

PATCH Mode____________________________________________________________________________________________14

7. PATCH Mode
Note: use Patch Mode of the Programmers only in conjunction with Microwave's Single Mode. While the Microwave is in
Multi Mode, the Programmer faultly requests the currently active Instrument number and not the Program number you
tuned in.
This is the mode to select Single Programs on your Microwave. Use Encoders 2 & 3 to select the Microwave's
current Program Number (or any other) and press YES. The Microwave MIDI Parameter „Prog Change" is
hopefully set to „ON", causing the Microwave to jump to the desired Program Number. Afterwards the
Programmer automatically requests the Program parameter data to allow displaying the original values in it's
display when turning knob.
Unfortunately the Microwave does not send any Program-Changes. This is why the Programmer can not sync
itself automatically if you select Programs directly on the Microwave. If you prefer selecting Programs on the
Microwave you perfectly can request the Program manually afterwards to get it into the Programmer.
After successful request the display should show something as
in the pic to the right. In the upper left corner you see the
currently requested Program Number. All parameters of this
Program are now in the Programmer's memory.
Using PRV and NEXT you can scroll through the Programs.
Helpful to find the right Sound. Incoming Midi notes are
forwarded to the Microwave of course to check out the
Program instantly. After each Program change the Programmer
is automatically up to date parameter-wize.
The 2nd line of the display shows the Program Number.
Now you are at Program A04 and want to jump quickly to C31?
Use encoders 2 & 3 for tuning in the desired Program.
Encoder 2 changes Bank A,B,C and D.
Encoder 3 sets the Number.
Confirm with YES
Press XIT to leave Patch Mode
Note: The requested patch will be associated with the currently active Multi Instrument. As explained in the Chapter
MULTI Mode the Programmer can only display original values for the Multi Instrument which was currently active while
requesting the Single Program. Which is 1 after powerup (or if the PREFS parameter MultInstSwap is set to OFF).
Synth Programmer for Waldorf Microwave – Operation manual V 1.0 – 01/2018
© Stereoping Germany, Meschede 2018