Fault Codes - GE JP3030*J series Technical Service Manual

Fault Codes

Fault Code Description
SEt Model number not programmed into UI
F10~F11 Problem with LED's on user interface
F61 Cannot communicate with induction module
that powers left coils
F62 Cannot communicate with Induction Module
that powers right coils
F63 Cannot communicate with induction module
that powers right coils
F70~F76 User Interface key fault
FA0 Fan Harness(is) not connected
FA1 Fan1 is not running at the correct Low speed Check wires connecting UI to Induction
FA2 Fan1 is not running at the correct High
speed
FA3 Fan2 is not running at the correct Low speed Check wires connecting UI to Induction
FA4 Fan2 is not running at the correct High
speed
FA5, FA9, FAA Bad coil thermistor reading
FA6 Low or high line voltage
FA7 Missing line frequency
FA8, FAB Bad induction driver (IGBT)
FAC Induction microprocessor fault
Possible Fixes / Service Checks
Program model number via service tools.
Check Power. Replace UI Board.
Check wires connecting UI to induction
Tray. Replace UI. Replace induction Tray.
Check wires connecting UI to induction
Tray. Replace UI. Replace induction Tray.
Check wires connecting UI to induction
Tray. Replace UI. Replace induction Tray.
Clean UI. Cycle power. Replace UI Board.
Check wires connecting UI to Induction
Tray. Check Fan, UI and induction Tray.
Replace fan.
Tray. Check Fan, UI and induction Tray.
Replace fan.
Check wires connecting UI to Induction
Tray. Check Fan, UI and induction Tray.
Replace fan.
Tray. Check Fan, UI and induction Tray.
Replace fan.
Check wires connecting UI to Induction
Tray. Check Fan, UI and induction Tray.
Replace fan.
Check coil thermistor and induction Tray.
Replace coil.
Check line voltage. Replace Induction Tray.
Check line voltage/frequency. Replace
Induction Tray.
Replace Induction Tray.
Replace Induction Tray.
– 36 –