GE JP3030*J series Technical Service Manual page 33

To Access the Induction Module
Remove two 1/4 in. hex head screws from each
induction element. Slightly rotate the elements from
under the tabs. When reinstalling the elements, note
the location of the notch and locating tab.
Loosen, don't remove, the two 1/4 in. hex head
screws for each element wire and disconnect the
two pin thermal sensor connector for each element.
NOTE: It is not necessary to remove the wire tie on
the element unless it is being replaced.
Remove ten 1/4 in. hex head screws from the
The induction cooling fan motor must be transferred
to the new module.
– 33 –