Linux - Avocent DSR2035 Installation & User Manual

14
DSR2035/8035 Switch Installer/User Guide
7. Click OK to save your settings and to close the Mouse Properties dialog box.
8. Resynchronize the mouse in the software remote session window for the Avocent management
software you are using:
• If you are using DSView software version 2.x or earlier, click Mouse Align.
• If you are using DSView software version 3.0 or later, click Align Local Cursor.
• If you are using the AVWorks software, click Screen Refresh.
The mouse resynchronizes and should work properly.
To adjust the mouse speed and pointer settings for IntelliPoint drivers:
1. From the Desktop taskbar, select Start - Control Panel to open the Control Panel.
2. From the Control Panel, double-click the Mouse icon to open the Mouse Properties dialog box.
3. Click the Pointer Options tab.
4. Set the Select a pointer speed slider to the default of midpoint (the fifth tick mark from
the left).
5. Clear the Enhance pointer precision checkbox.
6. Make sure the Snap To and the Visibility checkboxes are cleared.
7. Click the Wheel tab.
8. Clear the Enable accelerated scrolling ... checkbox.
9. Click OK to save your settings and to close the Mouse Properties dialog box.
10. Resynchronize the mouse in the software remote session window for the Avocent management
software you are using:
• If you are using DSView software version 2.x or earlier, click Mouse Align.
• If you are using DSView software version 3.0 or later, click Align Local Cursor.
• If you are using the AVWorks software, click Screen Refresh.
The mouse resynchronizes and should work properly.

LINUX

NOTE: Red Hat and SUSE support several standard graphical user interfaces. For this document, the Red Hat-
modified version of the GNOME graphical interface is shown, and the SUSE-modified version of the KDE
interface is shown. If your Red Hat installation uses the KDE graphical user interface, see the SUSE section or
refer to the KDE documentation online. If your SUSE installation uses the GNOME interface, refer to the Red Hat
section or refer to the GNOME documentation online.
To adjust the mouse speed and pointer settings for Red Hat LINUX pre-8.0 drivers
(modified GNOME GUI):
1. From the Workspace Menu, click the Desktop Manager icon and select Application Manager -
Desktop_Controls to open the Control Center dialog box.
2. From the tree view, select Peripherals - Mouse to list the mouse settings.