Table of Contents
Advertisement
f) Focus Tool
Focus Tool >
g) UCP (Universal Control Panel)
i) Viewer Tab, System Tab, Diagnostics Tab
ii) Settings: Material selections or Manual Mode settings
h) Red Dot Pointer – Red pointer beam turns on when the top door is open
i) "Dry run" or Practice Run – open door, run with door open - only the red dot
pointer light is on (CO2 laser does not come on). Lets you test alignment of jobs.
i) Job queue – print driver viewer screen shows a queue of jobs
j) Arm (#1 below) and Cover (#2 below) – structure that supports the lens carriage.
k) Motion System - electronics and mechanism that move lens carriage and arm.
l) Bearings (wheels that ride in v-groove channels in the arm) and Toothed Belt – parts
that support and drive the lens carriage, can be seen under the silver cover on the arm.
RNDC Checklist
02-08-2016
Hide quick links:
Advertisement
Table of Contents
