Table of Contents
Advertisement
g) It is OK to run in the "red light" mode with the lid open. Great for testing alignment
before you run a part.
h) Do not leave the machine unattended while running. It is possible to ignite some
materials if they are not run correctly. Remember, if you see a small flame, you can lift
the lid to stop the CO2 laser and can puff out the flame.
i) Must have a fire extinguisher available.
j) Filter and exhaust
i) Computer Controlled Air Filter Cart has been tested on authorized materials. It is
safe to run those materials in well ventilated office or production space. The filter cart
will not operate from the manual control driver.
ii) Show the three filters in the drawers, show how the covers must be put on correctly
and that the drawers must be closed.
k) There must be airflow clearance around the back and sides of the machine and air filter
cart – 1 foot all around.
l) Production area must be ventilated even with Filter Cart operating.
m) Do not run materials that are not specifically listed in the Materials Print Driver.
Unauthorized materials may be unsafe for use with the Filters.
8) Recommended Spares
a) Pre-filter
b) HEPA filter
c) Extra Cotton Swabs
d) Extra Lens Cleaner
e) Lens Kit
9) Engravers Network Contacts
Darrell Stephens
Robert Hensley
Engravers Network LLC
th
637 107
St.
Arlington, TX 76011
Phone: 817-261-7256
Fax: 800-210-4461
Email: dstephens@engraversnetwork.com
©2009 Engravers Network LLC. All rights reserved. Engravers Network logo and name, and Universal
Laser Systems are registered trademarks. All other company and product names are trademarks or
registered trademarks of their respective companies.
If you need support, contact Service or Training.
Have your Laser System Serial Number available.
RNDC Checklist
02-08-2016
Hide quick links:
Advertisement
Table of Contents
