Initial System Set-Up And Software Configuration; Driver Installation; Computer; Filter Life And Changes - Universal Laser Systems VLS3.50 Operation Manual

c) Filter life and changes
i) Change pre-filter when it gets very dirty
ii) Keep a spare HEPA filter. Vacuum switch trips when filter is full and you have to
replace it then. The machine with not operate with a HEPA filter that is clogged.
iii) Print driver keeps a record of Carbon Filter usage, will warn when one is needed.
Once it has reached its end of life, the system will not operate unless it is changed.

Initial System Set-Up and Software Configuration

1) Driver Installation – See the USER GUIDE for complete, illustrated instructions.
a) Insert the Software Installation CD-ROM into your PC‟s CD drive. It should
automatically launch the
"Laser" series for installation.
b) Select "Install Universal Control Panel" and "Install Printer Driver" in the
Installation Components screen, then select the "Next" button.
c) In the Select ULS Engraver Model screen select "VLS3.50" and click the "Next" button.
d) The installation process will proceed as indicated by a progress bar. Be patient. Loading
the files can take a few minutes depending on your computer‟s processor speed.
e) When the installation process is finished, the
Wizard" window will appear. Read the instructions and make your desired selection. If
you Reboot Now, save all your work prior to rebooting. If you decide to reboot later
remember that you must reboot before connecting the VLS system to your computer.
Click on the "Finish" button to complete installation. Window will automatically close.
f) Remove the Software Installation CD-ROM. All the files required to operate your
machine have been loaded onto your computer.
g) When driver is loaded, connect USB cable to laser system. Computer will show Found
New Hardware Wizard and will ask for confirmation to install. Click "Install the software
automatically" and then "Continue Anyway."
2) Computer (done by ULS for initial system shipment)
a) Create a folder "Laser Support" onto the computer desktop AND ONTO A
BACKUP CD. Copy your Print Driver disk into the folder. Also use the folder for any
special files or information relevant to the laser system so that it is easy to find.
b) When you first power up, look on the System Page. Record the "Tuning Value" in the
Operations Manual, and write it into a text file called "Tuning Value" and put it in the
Laser Support folder. Note: Tuning adjustment is needed only if a belt or laser tube is
replaced.
c) Turn off all Power Saving and Hibernate features in the Display Properties of computer.
d) Set VLS3.50 as default printer.
"Universal Control Panel
"Completing the ULS Software Setup
Installation" window. Select the
RNDC Checklist
02-08-2016