Winnebago PASEO 48P User Manual page 67

• 1st - Pull Black
Waste Tank Drain
valve to drain
black water
(sewage tank,
then close)
Sewage Drain Outlet
(Located beneath driver side coach)
NOTE: DO NOT OPEN BOTH VALVES AT
ONCE. Do not open the Gray Waste Tank
Drain valve until the black tank is
drained and dump valve closed to avoid
sewage back-up into gray tank. Gray
water also rinses any black water solids
from the sewage drain hose.
5. Open the Gray Waste Tank Drain valve. Be
sure there are no sags in the hose to ensure
complete drainage. Press and Hold Waste
Pump switch until tank is empty (do not run
pump dry.) Close Gray Waste Tank Drain
valve as soon as tank is empty.
NOTE: Sound of Waste Pump will change
significantly when tank is empty.
Waste Pump Switch
(Located beneath driver coach)
6. Store sewage drain hose.
• 2nd - Pull Gray Waste
Tank Drain valve to
drain gray water (sink/
shower, then close)
7. Add an odor control chemical to the sewage
holding tank through the toilet. These
chemicals are available at most RV stores.
NOTE: We recommend that you dump all
holding tanks before traveling to avoid
carrying unnecessary weight.
Flushing Your Black Waste Holding
Tank
The black waste holding tank is equipped with
an internal spray head that allows you to rinse the
inside of the tank with a shower of clean water
after dumping.
CAUTION
Do not use the tank flush inlet unless the
fullway termination valve is in the open
position. May result in an unsanitary
condition leading to illness or personal
injury.
1. Dump your black waste holding tank in the
usual manner at an approved sewage disposal
station.
2. Leave Black Waste Tank Drain valve open
while flushing tank.
3. Attach a garden hose from a city water
hydrant to the Black Waste Tank Flush Inlet
fitting on the right sidewall. (This inlet is
clearly marked separate from the City Water
inlet).
SECTION 7 –
PLUMBING
7-13