Table of Contents
Advertisement
BACK
BACK
(11)
(12)
PDF created with FinePrint pdfFactory trial version
SIDE
BATTERY CASE
BELT CLIP
8
http://www.pdffactory.com
Chapter 8 : TECHNICAL SPECIFICATIONS
The technical specification details of Twin Stim
MECHANISM
TECHNICAL DESCRIPTION
01 Channel
Four, isolated between channels
02 Pulse Amplitude
Adjustable, 0-100 mA peak into 500 ohm
load each channel.
03 Wave Form
Asymmetrical Bi-Phasic Square Pulse
04 Voltage
0 to 50V (Load: 500 ohm)
05 Power source
Four AA batteries
06 Size
13.8cm(L) x 7.8cm(W) x 2.8cm(H)
07 Weight
425 grams with battery.
08 Pulse Rate
Adjustable, from 2 to 150 Hz, 1 Hz/step
09 Pulse Width
Adjustable, from 50 to 300 microseconds,
10 µs/step
10 On Time
Adjustable, 2~90 seconds , 1 Sec./ step
11 Off Time
Adjustable, 0~90 seconds , 1 Sec./ step
12 Ramp Time
Adjustable, 1~8 seconds, 1 Sec./ step, The
"On" time will increase and decrease in the
setting value.
13 Mode
Five TENS Modes: B(Burst), N(Normal),M
(Modulation),SD1( Strength Duration), SD2
Three EMS Modes:C(Constant) S
(Synchronous), A(Alternate)
14 Burst Mode
Burst rate: Adjustable, 0.5 ~ 5Hz
Pulse width adjustable, 50~300µs
Frequency fixed = 100 Hz
15 Normal Mode
The pulse rate and pulse width are
adjustable. It generates continuous
stimulation based on the setting value.
16 Modulation Mode Modulation mode is a combination of pulse
rate and pulse width modulation. The pulse
9
®
Plus are as follows:
Hide quick links:
Advertisement
Table of Contents
