Tens Twin Stim Plus Instruction Manual page 16

Pulse Width is adjustable from 50 uS to 300 uS. Press "SET"
control to enter this menu, then press "Increment" or
"Decrement" to adjust the setting. If no instructions regarding
the pulse width are given in therapy, set the control to the
suggested 70-120 uS setting.
l. Set Pulse Rate
Pulse rate is adjustable from 2Hz to 150 Hz . Press "SET"
control to enter this menu, then press "Increment" or
"Decrement" to adjust the setting. Unless otherwise instructed,
turn the pulse rate control to the 70-120 Hz range.
m.Set Timer
There are two adjustable timers available. The left timer
controlling the treatment time of CH1 and CH2.
The right timer controlling the treatment time of CH3 & CH4.
The treatment time is adjustable from 1 to 60 minutes or C
(Continuous). Press "SET" control to enter this menu, then
press "Increment" or "Decrement" to adjust the setting.
Press "Increment" control when the timer shows 60 minutes,
it will be switched to continuous stimulation.
When you use the EMS treatment, the intensity level will flash
when it is at "OFF" time (relaxation). The intensity level can not
be adjusted until it works again at "ON" time.
PDF created with FinePrint pdfFactory trial version
28
http://www.pdffactory.com
Left Timer RightTimer
12. Compliance Meter
This unit can store 60 sets of operation records. Total treatment
time up to 999 hours can be stored.
Check & Delete Individual Record
Press "Mode" control and turn on the power simultaneously.
The LCD will show the number of records and operation time.
Press the "Increment" and "Decrement button to check each
record.
To delete a record, press "SET" control for 3 seconds.
Check & Delete Accumulative Record
At the individual records menu, press "Mode" control to switch
to accumulative record menu. Press the "SET" control first, then
press the "Mode" control simultaneously for 3 seconds and all of
the records will be deleted followed by a beeper sound.
29
Continuous