Related Manuals for Tens Twin Stim Plus
Summary of Contents for Tens Twin Stim Plus
- Page 1 INSTRUCTION MANUAL INSTRUCTION MANUAL FOR THE Twin Stim Plus DIGITAL TENS/EMS Distributed by: FDA 510K V1.0 PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com...
-
Page 2: Table Of Contents
INDEX Chapter Contents Page General Description ..........2 Introduction ............2 Cautions ..............4 Warnings ..............6 Contraindications ..........6 Adverse Reactions ..........6 Construction ............7 Technical Specifications ........9 Replaceable Parts ..........13 10 Accessories ............13 11. Graphic Symbols ........... 14 12. -
Page 3: General Description
The Twin Stim Plus Digital TENS/EMS is a battery operated pulse Stimulation (TENS). TENS is intended to be used to relieve pain. The generator that sends electrical impulses electrodes to the body and TENS unit sends comfortable impulses through the skin that stimulate the nerve (or nerves) in the treatment area. -
Page 4: Cautions
(Stimulation, Contraction and Relaxation.) Powered 9. Turn the TENS off before applying or removing electrodes. muscle stimulators should only be used under medical supervision 10. Isolated cases of skin irritation may occur at the site of electrode for adjunctive therapy for the treatment of medical diseases and placement following long term application. -
Page 5: Warnings
10.Portable powered muscle stimulators should not be used while Chapter 7 : CONSTRUCTION driving, operating machinery, or during any activity in which involuntary muscle contractions may put the user at undue risk of injury. Chapter 4 : WARNINGS 1. The long-term effects of chronic electrical stimulation are unknown. -
Page 6: Technical Specifications
Adjustable, 0~90 seconds , 1 Sec./ step 12 Ramp Time Adjustable, 1~8 seconds, 1 Sec./ step, The “On” time will increase and decrease in the setting value. 13 Mode Five TENS Modes: B(Burst), N(Normal),M (Modulation),SD1( Strength Duration), SD2 BACK Three EMS Modes:C(Constant) S (11) BATTERY CASE... - Page 7 “Normal” mode of a TENS unit. rate and width are automatically varied in a cycle pattern. The pulse width is decreased 20 Synchronous Stimulation of both channels occurs by 50% from its original setting in 0.5 second, synchronously. The “ON” time including...
-
Page 8: Replaceable Parts
The waveforms of the TENS modes are as follows. Chapter 9 : REPLACEABLE PARTS 1. Burst ® The replaceable parts and accessories of Twin Stim Plus Digital TENS/EMS devices are as given below – Except leads, electrodes, battery and battery case cover, please do not try to replace the other parts of a device. -
Page 9: Graphic Symbols
6) Select the mode and settings as directed by your physician. II. LABEL 7) There are 4 sets of intensity buttons, which correlate to each of The label attached to the back of device contains important the 4 channels. Slowly increase or decrease the intensity as directed by your physician by pressing the up or down Intensity information about this device- buttons. - Page 10 However, in some cases, pain relief may take as long as 30 minutes to achieve, especially when using point Burst Mode is analogous to the Low Rate TENS technique except the electrode placements and slow pulse rates.
-
Page 11: Lead Wire Maintenance
Chapter 17: ELECTRODE PLACEMENT The placement of electrodes can be one of the most important parameters in achieving success with TENS or EMS therapy. Of utmost importance is the willingness of the physician to try the various styles of electrode placement to find which method best fits the needs of the individual patient. -
Page 12: Tips For Skin Care
Chapter 18: TIPS FOR SKIN CARE Removal 1. Turn off the unit prior to removing the electrodes. To avoid skin irritation, especially if you have sensitive skin, follow 2. Lift at the edge of electrodes and peel; do not pull on the lead these suggestions: wires because it may damage the electrodes. -
Page 13: Adjusting The Controls
1. Panel Cover: A lid covers the controls for selecting mode and adjusting settings. There are 5 TENS modes(B, N, M, SD1, SD2) and 2 EMS modes Your medical professional may wish to set these controls for you (S, A) available. The mode can be selected by pressing the “Mode”... - Page 14 There are 5 modes of your option including –B(Burst), M(Normal), M (Modulation), SD1 and SD2. When a TENS mode is selected, it shows “TENS” on the top of liquid crystal display.
- Page 15 i. Set On Time button. The menu will reveal on LCD. Notice the indication of The On Time controls the time of stimulation. By pressing the power and function on the LCD. “Set” control, the contraction time can be adjusted. Both channels’...
- Page 16 Pulse Width is adjustable from 50 uS to 300 uS. Press “SET” control to enter this menu, then press “Increment” or “Decrement” to adjust the setting. If no instructions regarding the pulse width are given in therapy, set the control to the suggested 70-120 uS setting.
-
Page 17: Battery Information
13. Check/Replace the Battery: BATTERY CHARGING Over time, in order to ensure the functional (1) Plug the charger into any working 110 or 220/240v mains electrical safety of the unit, changing the battery is outlet. The use of any attachment not supplied with the charger necessary. -
Page 18: Safety-Technical Controls
- for possible damage to the cable. Change the cable if any damage accessories in carrying box and keep it in cool dry place. 6. The packed TENS/ EMS device should be stored and transported is detected. under the temperature range of -20°C ~ + 60°C, relative humidity 20%~ 95%, atmosphere pressure 500 hPa~ 1060 hPa. - Page 19 PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com...