Dionex Reagent-Free Controller (Dionex Rfc); Dionex Scc-10 Suppressor Current Controller (Item # 074053) - Thermo Scientific Dionex ERS 500 Product Manual

2 – Installation
The Dionex AERS 500 Carbonate suppressor has different electrical current requirements
than the Dionex AERS 500 suppressor. If an AERS Carbonate mode is not available the
current applied to a Dionex AERS 500 Carbonate should be adjusted by a factor of 1.30
!
compared to a standard AERS 500 suppressor. Chromeleon 7.2 SR3 MUa and later
versions have an option for selecting an AERS_Carbonate suppressor in the Instrument
NOTE
Method Wizard and Editor dialog box. Selecting this suppressor from the drop-down list
will automatically apply the recommended current setting for Dionex AERS 500 Carbonate
suppressors.
2.2.1

Dionex Reagent-Free Controller (Dionex RFC)

The Dionex Reagent-Free Controller (Dionex RFC) is an external power supply available in two
versions.


! If an ERS Mode is not available, select the equivalent SRS Mode on the power supply to
support the Dionex ERS 500 suppressor. The Dionex ERS 500 and Dionex ERS 500e are
fully compatible with SRS settings.
NOTE
The Dionex AERS 500 Carbonate suppressor has different electrical current requirements
!
than the Dionex AERS 500 suppressor. If an AERS Carbonate mode is not available the
current applied to a Dionex AERS 500 Carbonate should be adjusted by a factor of 1.30
NOTE
compared to a standard AERS 500 suppressor.
The Dionex RFC controls these devices by supplying current to the suppressor and for the
Dionex RFC-30, current to the eluent generator and voltage to the Dionex CR-TC. Please see
the Dionex RFC Operator's Manual for suppressor operating and installation instructions with
the following Dionex products:




2.3 Dionex SCC-10 Suppressor current controller (Item # 074053)

The Dionex SCC-10 is an external controller designed for use with legacy instruments that only
offer four settings for suppressor current, and is recommended for optimal performance. The
Dionex SCC-10 is powered from the existing suppressor current supply, and can output twelve
discrete current settings from 10 mA to 250 mA.
!
The Dionex SCC-10 external controller is recommended when using legacy instruments
that only offer four settings for suppressor current to achieve optimum performance.
NOTE
Thermo Scientific
031956-11
The Dionex RFC-10 controls the Dionex ERS 500 Electrolytically Regenerated
Suppressor. Current is delivered at 1 mA resolution.
The Dionex RFC-30 controls an Dionex ERS 500 Electrolytically Regenerated
Suppressor, as well as a Dionex Eluent Generator Cartridge (Dionex EGC) and a
Dionex CR-TC Continuously Regenerated Trap Column. Current is delivered at 1 mA
resolution.
Dionex DX-320/320J
Dionex DX-500, Dionex DX-600, or Dionex ICS-2500
Dionex DX-120
Product Manual for the ERS 500 Suppressor
For Research Use Only. Not for Use in Diagnostic Procedures.
Page 23 of 84