Cisco NCS 5500 Series Configuration Manual page 165

BGP-based VPWS Autodiscovery
Example:
RP/0/RP0/CPU0:router(config-l2vpn-xc-m2mp)# vpn-id 100
Specifies the identifier for the VPWS service.
Step 6 l2 encapsulation vlan
Example:
RP/0/RP0/CPU0:router(config-l2vpn-xc-mp2mp)#l2-encapsulation vlan
Configure the L2 encapsulation for this L2VPN MP2MP Instance.
Step 7
autodiscovery bgp
Example:
RP/0/RP0/CPU0:router(config-l2vpn-xc-mp2mp)#autodiscovery bgp
Enters BGP autodiscovery configuration mode where all BGP autodiscovery parameters are configured.
Step 8 rd { as-number:nn | ip-address:nn | auto }
Example:
RP/0/RP0/CPU0:router(config-l2vpn-xc-mp2mp-ad)# rd auto
Specifies the route distinguisher (RD).
Step 9 route-target { as-number:nn | ip-address:nn | export | import }
Example:
RP/0/RP0/CPU0:router(config-l2vpn-xc-mp2mp-ad)# route-target 500:99
Specifies the route target (RT).
Step 10
signaling-protocol bgp
Example:
RP/0/RP0/CPU0:router(config-l2vpn-xc-mp2mp-ad)# signaling-protocol bgp
Enables BGP signaling, and enters the BGP signaling configuration submode where BGP signaling parameters are
configured.
Step 11
ce-id { number}
Example:
RP/0/RP0/CPU0:router(config-l2vpn-xc-mp2mp-ad-sig)# ce-id 10
Specifies the local Customer Edge Identifier.
Step 12 Use the commit or end command.
Configuring VPWS with BGP Autodiscovery and Signaling
BGP Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.2.x
155