Start-Up And Use - Ariston FTGHG 751 D/A LPG Operating Instructions Manual

Table of Contents

Advertisement

Start-up and use

GB
! The position of the corresponding gas burner is shown on every knob.
Gas burners
Each burner can be adjusted to one of the following settings using the
corresponding control knob:
Off
Maximum
Minimum
To turn on one of the burners, place a lighted match or lighter near the burner,
press the knob all the way in and turn it anti-clockwise to the "High" setting.
The knob must be pressed in for about 2-3 seconds until the device that keeps
the flame lit warms up.
Some models are equipped with an ignition button incorporated into the control
knob. If this is the case, the ignitor is present. To light a burner, simply press the
corresponding knob all the way in and then turn it anti-clockwise to the "High"
setting, keeping it pressed in until the burner lights.
! If a flame is accidentally extinguished, turn off the control knob and wait for
at least 1 minute before trying to relight it.
To switch off the burner, turn the knob in a clockwise direction until it stops
(when reaches the "●" position).
Do not place anything, eg.
flame tamer, griddle plate
between pan and pan support
as serious damage to the
appliance may result.
Practical advice on using the burners
To ensure the burners operate efficiently:
• Use appropriate cookware for each burner (see table) so that the flames
do not extend beyond the bottom of the cookware.
• Always use cookware with a flat base and a cover.
• When the contents of the pan reach boiling point, turn the knob to minimum.
Burner
Rapid (R)
Semi Rapid (S)
Auxiliary (A)
To identify the type of burner, refer to the designs in the section entitled, "Burner
and Nozzle Specifications".
! Make sure the pans do not overlap the edges of the hob while it is being used.
• For maximum stability, always make sure that the pan supports are
correctly fitted and that each pan is placed centrally over the burner.
• Pan handles should be positioned in line with one of the support bars on
the pan support grid.
• Pan handle should be positioned so not to protrude beyond the front edge
of the hob.
8
Do not remove the pan
Do not use large pots or heavy
support and enclose the
weights which can bend the
burner with a wok stand as
pan support or deflect flame
this will concentrate and
onto the hotplate.
deflect heat onto the
hotplate.
Ø Cookware Diameter (cm)
24 - 26
16 - 20
10 - 14
The more variable aspect in terms of pan
stability can often be the pan itself, (or
the positioning of that pan during use).
Well balanced pans, with flat bases that
are placed centrally over the burner, with
the pan handles aligned with one of the
support fingers obviously offer the greatest stability.
Correct positioning of the FTGH burners
Precautions and tips
! This appliance has been designed and manufactured in compliance with
international safety standards. The following warnings are provided for safety
reasons and must be read carefully.
General safety
• This is a class 3 built-in appliance.
• Gas appliances require regular air exchange to maintain efficient
operation. When installing the hob, follow the instructions provided
in the paragraph on "Positioning" the appliance.
• These instructions are only valid for the countries whose symbols
appear in the manual and on the serial number plate.
• The appliance was designed for domestic use inside the home and is
not intended for commercial or industrial use.
• The appliance must not be installed outdoors, even in covered areas. It is
extremely dangerous to leave the appliance exposed to rain and storms.
• Do not touch the appliance with bare feet or with wet or damp hands and
feet.
• The appliance must be used by adults only for the preparation of food,
in accordance with the instructions outlined in this booklet. Any other
use of the appliance (e.g. for heating the room) constitutes improper
use and is dangerous. The manufacturer may not be held liable for
any damage resulting from improper, incorrect and unreasonable
use of the appliance.
• The openings used for ventilation and dispersion of heat must never be
covered.
• Always make sure the knobs are in the "●"/"○" position when the appliance
is not in use.
• When unplugging the appliance always pull the plug from the mains socket,
do not pull on the cable.
• Never carry out any cleaning or maintenance work without having detached
the plug from the mains.
• Where this appliance is installed in marine craft or in caravans, it shall not
be used as a space heater.
• In case of malfunction, under no circumstances should you attempt to repair
the appliance yourself. Repairs carried out by inexperienced persons may

Advertisement

Table of Contents
loading

Table of Contents