Default Settings - 3Com 3C17203 Getting Started Manual

Default Settings

Table 6 shows the default settings for the Switch 4400:
Table 6 Default Settings
Feature
Automatic IP Configuration
Port Status
Port Speed
Duplex Mode
Flow Control
Broadcast Storm Control
Virtual LANs (VLANs)
IP Multicast Filtering
Rapid Spanning Tree Protocol Enabled
RMON Alarm
Smart Auto-Sensing
Webcache Support
Quality of Service (QoS)
Webcache support and Quality of Service (QoS) are not available on the
SuperStack 3 Switch 4400 SE unless the product has been upgraded to
the 4400 enhanced feature set.
If you initialize a Switch unit by selecting System > Control > Initialize in
the Web interface or by entering system control initialize in
the Command Line Interface, the following settings are retained to allow
you to connect to and manage the Switch:
IP Address
■
Subnet Mask
■
Default Router
■
Switch 4400
Enabled
Enabled
10/100 Mbps ports are auto-negotiated
All fixed 10BASE-T and 100BASE-TX ports are
auto-negotiated
Enabled in half duplex
■
Auto-negotiated in full duplex
■
Enabled
All ports belong to the untagged Default VLAN
(VLAN 1) with 802.1Q learning operational
Filtering enabled
Fast Start:
Enabled on front panel ports
■
Disabled on rear panel port
■
Enabled
Enabled
Disabled
All ports prioritize NBX VoIP traffic (LAN and IP).
All ports set to "best effort" for all other traffic.
Default Settings 19