28
C
3: C
HAPTER
ONFIGURING THE
Clearing and
Applying System
Configuration
Settings
B
RIDGE
Table 8 Connection Status Page (continued)
Current Channel
The channel over which the Bridge
is communicating with clients.
Security
The type of security for which the
Bridge is configured.
Rx Data Rate (Mbps) The most recent data reception
rate.
Tx Data Rate (Mbps) The most recent data transmission
rate.
Link Quality
The normalized transmitted data
rate (that is, the current data rate
over the maximum data rate).
Note: Link Quality is shown in
Infrastructure mode only.
Received Signal
The strength of the radio signal
Strength
that the Bridge detects.
Note: Received Signal Strength is
shown in Infrastructure mode only.
Activity (Packets Rx)
The number of packets the Bridge
has received.
Activity (Packets Tx)
The number of packets the Bridge
has transmitted.
IP Address
The IP address of the Bridge.
The pages in the Configuration Management System have two buttons:
Clear and Apply.
Clear returns the settings to the values they were when you last
■
clicked Apply.
Apply stores the settings permanently in the nonvolatile flash memory.
■
After you click Apply, the new settings take effect and you can see the
changes on the System Summary page.
CAUTION: Your changes are lost if you forget to
moving to a new configuration page.
Varies
Open System
(no security)
N/A
N/A
N/A
N/A
N/A
N/A
Varies
Apply
click
before