Inserting Multi-Conductor Cable - Neptune TRICON E Installation And Maintenance Manual

4 Strip the outer covering of the cable back approximately 1
5 Separate the individual conductors and strip the insulation back approximately
of each conductor.
6 Using the rounded shaft of the screwdriver, form a hook in the end of each bare copper wire.
(See Figure 2.3.)
7 Loosen the terminal screws, as shown in Figure 2.4.
8 Position the wire hook of each conductor under the proper terminal screw according to the
appropriate wiring diagram.
Refer to Figure 2.5 and Table 2.1 for the wiring diagram.
TRICON/E/E2/E3 TRANSMITTER INSTALLATION AND MAINTENANCE GUIDE
Figure 2.2 Inserting Multi-Conductor Cable
Figure 2.2 Inserting Multi-Conductor Cable
Figure 2.2 Inserting Multi-Conductor Cable
Figure 2.3 Creating a Hook in the Wire
Figure 2.3 Creating a Hook in the Wire
Figure 2.3 Creating a Hook in the Wire
Figure 2.4 Connecting the Conductors to the Terminal Screws
Figure 2.4 Connecting the Conductors to the Terminal Screws
Figure 2.4 Connecting the Conductors to the Terminal Screws
⁄ " from the inserted end.
1
2
⁄ " from the end
1
2
2-3