Table of Contents
Advertisement
FastTrak S150 TX4 User Manual
New Windows XP Installation
The following details the installation of the FastTrak TX4 drivers while installing
Windows XP.
1.
Start the installation:
•
Floppy Install: Boot the computer with the Windows XP installation
diskettes.
•
CD-ROM Install: Boot from the CD-ROM. Press F6 after the message
"Press F6 if you need to install third party SCSI or RAID driver"
appears.
2.
When the Windows XP Setup window is generated, press S to specify an
Additional Device(s).
3.
Insert the FastTrak TX4 driver diskette into drive A: and press Enter.
4.
Choose WinXP Promise FastTrak TX4000/S150 TX Series Controller from
the list that appears on screen, and then press the Enter.
5.
Press S to use the driver on the floppy disk and then press Enter to
continue with installation.
6.
The Windows XP Setup screen will appear again saying "Setup will load
support for the following mass storage devices:" The list will include "WinXP
Promise FastTrak TX4000/S150 TX Series Controller".
NOTE: If there are any additional devices to be installed, specify them now.
When all devices are specified, continue to the next step.
7.
From the Windows XP Setup screen, press the Enter. Setup will now load
all device files and then continue the Windows XP installation.
34
Hide quick links:
Advertisement
Table of Contents
