Installing The Fasttrak Card - Promise Technology FastTrak S150 User Manual

FastTrak S150 TX4 User Manual

Installing the FastTrak Card

The FastTrak TX4 Serial ATA RAID card fits into any available PCI slot on your
PC's motherboard (see Figure 1, below):
•
32-bit PCI slot (must be PCI 2.2 or 2.3 compliant)
•
The 32-bit portion of a 64-bit PCI slot
1. Remove the cover of your system.
2. Remove the inside slot cover of an available 32-bit PCI slot on the
motherboard.
3. Install the FastTrak Serial ATA RAID card into the open slot (see Figure 1
below). Secure the bracket to the system's frame.
4. Attach your system case's 2- or 4-pin LED cable to the LED connector on
the FastTrak S150 TX4 RAID card (see Figure 2, on page 8). Make sure
that pin 1 on the connector is aligned with pin 1 of the cable.
5. Fasten the controller card bracket to the system case (see below).
Figure 1.
Insert the FastTrak card into an open PCI slot
6