Philips HR1840 Manual page 10

ENGLISH
10
2
1
C
2 Insert the sieve.
Always check the sieve before use. Do not use the sieve if you notice
any damage on it like cracks, fissures, opening on metal screen or loose
grater disc.
In case of a damaged sieve, contact the Philips Customer Care Centre
in your country (you will find its phone number in the worldwide
guarantee leaflet). If there is no Customer Care Centre in your country,
turn to your local Philips dealer or contact the Service Department of
Philips Domestic Appliances and Personal Care BV.
C
3 Put the lid in place and finally fasten the clamp by pushing it
down.
Make sure the clamp is on the right side of the motor unit. Check if the
lid is properly assembled and fastened.
C
4 Put the juice cup in place.
5 Select the right speed setting to switch the appliance on.
Ingredients to process
Fruits (soft)
Fresh coconut, beetroots (hard)
C
6 Put the ingredients in the feeding tube. Before processing, cut
large ingredients into pieces that fit into the feeding tube.
C
7 Push the ingredients gently down with the pusher.
Do not exert too much pressure on the pusher, since this would affect
the quality of the end result and it could even cause the sieve to come
to a halt.
8 If no more juice comes out, switch the appliance off and wait
until the sieve has stopped rotating before releasing the clamp.
9 Remove the juice cup.
For recipes see further on in this booklet.
B
Do not let the juice extractor run contnously for more than 2 minutes
If you have not finished extracting juice, switch the appliance off and
allow it to cool down for 2 minutes before you continue.
Speed
speed 1
speed 2