Table of Contents
Advertisement
To install a 3.5-inch Serial ATA hard disk drive to the left HDD bay:
1.
Remove the assembly module from
the chassis. Refer to 2.5.1 Removing
the assembly module for more
information.
2.
Insert and carefully push the HDD
into the bay until its screw holes align
with the holes on the bay.
3.
Secure the HDD with four (4) screws
into the screw holes shown in the
illustration.
4.
Connect the SATA cable to the
SATA connector of the drive.
5.
Connect a SATA power cable from
the power supply to the power
connector of the drive.
6.
Reinstall the assembly module and
front panel cover. Refer to 2.5.2
Replacing the assembly module and
front cover for more information.
ASUS ESC500 G4 SFF
Screw holes
Screw holes
2-13
Advertisement
Table of Contents
