Table of Contents
Advertisement
2.7
Card reader
To install a card reader to the assembly module:
1.
Remove the assembly module from
the chassis. Refer to 2.5.1 Removing
the assembly module for more
information.
2.
Insert and carefully push the card
reader into the bay until its screw
holes align with the holes on the bay.
3.
Secure the card reader with two (2) screws into the screw holes on the right side of the
assembly module, and one (1) screw on the left side of the assembly module.
4.
Connect the connector to the bundled USB 3.0 cable, then connect the USB 3.0 cable
to the USB3_34 connector on the motherboard.
Refer to section 3.4 Internal connectors for the location of the USB3_34 connector.
ASUS ESC500 G4 SFF
Screw holes
2-11
Advertisement
Table of Contents
